Select Page

cPCI 3U Load Board

Load boards are essential in keeping any system in top running shape. As a full-system provider, Hartmann strives to not only provide the systems you need, but the supporting hardware as well.

The cPCI Load Test Board serves to simulate loads on cPCI systems. The load board switches itself off at a temperature on the topside of the load test card or in a rack at 120 degrees Celcius +/- 5K. Once cooled, it turns itself back on.

Additional Information

Form Factor

3U

Slot Pitch

4HP (20.32 mm)

Function

simulate resistive loads on cPCI systems for both electrical and thermal conditions

Cooling

Air cooled (with heat sink) or conduction cooled

Permissible Current Load

5V 0A … 8.25A in 0.55A steps, 3V3 0A … 10.5A in 0.7A steps, +12V 1A, ON/OFF, -12V 1A, ON/OFF

Control Voltage

5V, required

Voltage and Temperature Measurement

4 PTC resistors; one each at the front at bottom and top to allow temperature measurements in chassis condition, Optional DVM plug-on board, Voltage and temperature sense lines are connected to 2 x 8 pin header (X1 connector) on front panel

Thermal Protection

Automatic shut-off if any temperature is exceeding 120°C (+/-5K), Re-energizing after cooling dow, Re-energizing after cooling down

Downloads

Contact Us

Discover how Hartmann can increase power, speed and rugged durability to your project performance.

Hartmann Electronic

Germany Headquarters
Motorstr. 43
D-70499 Stuttgart, Germany
P:+49 711 13 98 90
North American Office
202 N. Limestone St. Suite 320
Springfield, Ohio 45503
P:+1 937-324-4422
  • This field is for validation purposes and should be left unchanged.