CompactPCI Load Board 3U
Features at a Glance:
-
The cPCI Load Test Board serves to simulate loads on cPCI systems
-
The load board switches itself off at a temperature on the topside of the load test card or in a rack at 120 degrees Celcius +/- 5K. Once cooled, it turns itself back on
-
5V must always be connected as control voltage
-
Voltages are tapped at the cPCI bus via the P1 plug
-
The incoming voltage levels for the voltages 5V, +12V, 3.3V, and -12V can be measured at the measuring points close to the plug P1. These measuring points are run via the plug X1 (on the front plate)
-
4 PTC resistors (PT100) are attached to the load test card: On the front at bottom and top, and on the back at bottom and top. These PTS resistor connections are also run via the plug X1
